Manuals / Moyer Diebel / Kitchen Appliance / Dishwasher

Moyer Diebel 301HT M2 Initial Start Up, The door must be closed to begin the cycle

Models: 301HT M2

1 50

Download 50 pages 12.29 Kb

Page 15

1.The door must be closed to begin the cycle.

Installation

Initial Start Up

The following is a summary of your model 301HT dishwasher operating cycle:

1.The door must be closed to begin the cycle.

2.Press the POWER button to fill the wash tank.

3.The booster heater comes on when the correct water level has been reached.

4.Press and hold the START button to start the cycle. NOTE : After pushing the start button the first cycle of each day could take at least 15-20 minutes if the machine was not allowed to warm up first.

5.The pump runs during the wash cycle for approximately 120 seconds. The wash cycle duration is extended if the booster water temperature does not reach 180°F/82°C.

6.After a 5 second pause, the fill valve opens and the rinse cycle starts.

7.The machine rinses for 15 seconds. The cycle light turns off indicating that the cycle is complete. DO NOT open the door until the cycle light turns off.

8.Open the door and remove the rack of clean ware.

7

Image 15

Moyer Diebel 301HT M2 installation manual Initial Start Up, The door must be closed to begin the cycle

Contents

301HT M2 Undercounter High Temperature DishwasherInstallation Manual with Service Replacement Parts Manual P/N 114150 rev. BModel Number Serial Number VoltageHertz Phase FIRST-CLASS MAIL PERMIT NO. 2101 WINSTON-SALEM, NC BUSINESS REPLY MAILMOYER DIEBEL PO BOX 4183 WINSTON-SALEM, NC NO POSTAGE NECESSARY IF MAILED IN THE UNITED STATESThis Card Must Be Returned to Validate Machine Warranty WARRANTY REGISTRATION CARDWARRANTY REGISTRATION CARD This Card Must Be Returned to Validate Machine WarrantySerial Number Revision HistoryRevision RevisedLimited Warranty Limited WarrantyService Replacement Parts Table of ContentsInstallation Operation Cleaning De-liming Maintenance TroubleshootingModel Descriptions Model 301HT M2Options Receiving Receiving installationElectrical Connections Plumbing Connections Water ConnectionsDrain Connections Chemical Dispensers Completing the InstallationDetergent Rinse AidInitial Start-up Initial Start Up1. The door must be closed to begin the cycle Initial Start UpNote DO NOT OVERLOAD the rack Operation ProceduresOperation This procedure is only needed when the tank is emptyCleaning After Meal Periods or 8 Hours of OperationWeekly De-liming De-liming ProcedureDanger Monthly Maintenance MaintenanceCleaning Schedule Daily MaintenanceCause TroubleshootingSolution ConditionKeep wash water as clean as possible TroubleshootingSolution Wash water temperature too lowBlank Page This Page Intentionally Left BlankService Replacement Parts IllustrationsPage Hood and Tank Assembly Item No DescriptionUnit Door Assembly H25791 Rinse-aid Wash Tank Heater and Chemical Dispenserspump DetergentSqueeze Tube, Rinse comes with black fittings Squeeze Tube, Detergent comes with black fittingsFill Piping Assembly H36156 Drain Assembly To Drain1614 H32796 BOTTOM OF TAN Wash and Rinse Piping Assembly0502563 Wash and Rinse Arm Assemblies Bearing, Wash Arm Wash Pump/Motor Assembly H36354 Booster Heater Assembly H36250 Control Panel Assembly Start Switch Push button only does not include Item Thermometer Does not include ItemBeginning with S/N 66190 and above Control Cabinet Assembly H160121 Blank Page This page intentionally left blankElectrical Schematics and Timing Chart Electrical Schematic and Timing ChartElectrical Schematic Timing Chart