OPERATING INSTRUCTIONS
CONNECT THE CORD
1.Ensure the cord is NOT plugged into a receptacle before this procedure.
2.Make a loop with 8″ - 10″ (20 - 25cm) of the end of the extension cord.
3.Place the loop into the slot (A) under the rear handle and lock into place on the cord retainer (B) as shown in Figure 1.
4.Plug the extension cord into the electrical receptacle in the snow thrower handle.
5.Plug the extension cord into a receptacle ONLY when you are ready to operate the snow thrower.
A
B
Fig. 1
ADJUST SHAFT LENGTH
1.Loosen the adjustment ring (A) by rotating the ring clockwise.
2.Adjust the shaft to a height that is comfortable to you.
3.Tighten the adjustment ring (A) by rotating the ring (A) counter clockwise. (Fig. 2)
A
Fig. 2
POSITIONING THE ASSIST HANDLE
1.Loosen the knob (A) on the assist handle (B). (Fig. 3)
2.Adjust the assist handle to an angle that is comfort- able to you.
3.Tighten the knob on the assist handle.
B
A
Fig. 3
STARTING AND STOPPING
To start the snow thrower, push the button (A) on the side of the handle grip and squeeze the trigger (B). To stop the product, release the trigger. (Fig. 4)
NOTE: When properly started, the safety button will stay engaged when holding the trigger. When the trigger is released, the unit stops and the safety button will disen- gage.
A
B
Fig. 4
8
