MTD 19A30002000, OEM-190-180A manual Make sure screen sits under the cover’s lip

3.Install the bagger screen into the bagger cover by first inserting the end closest to the side with the cutout into the mounting hole, as in Fig. 4-12. Make sure to feed the screen under the lip, as in Fig. 4-13.

Figure 4-12

4.Clip in the other side by pushing the screen into the provided cutout. See Fig. 4-13.

Make sure screen sits under the cover’s lip

Figure 4-13

5.Install the bagger cover onto the bag support assembly, as seen in Fig. 4-14. The plastic cover goes inside of the two mounting tabs.

6.Slide the hinge pin into the hole located on the mounting tab, as in Fig. 4-15. Use the cut-out window (See inset in Fig. 4-15) to line up the hinge pin on the other side and push pin all the way in until it reaches the end-stop. At this point the pin clips into place and is secured by a tab in the bagger cover. See Fig. 4-16.

Figure 4-14

Figure 4-15

Figure 4-16

Section 4 — Assembly & Installation

13