MTD 19A30002000 Series Tractors Only, Assembly & Installation, with bolts from hardware pack

Assembly & Installation

700 Series Tractors Only

If you are assembling this bagger unit for use on any model 700 series tractor you will need to install the two tractor mounting brackets packed in your bagger kit. If you are installing this bagger unit on any other tractor, disregard these steps and move to Assemble Mounting Brackets on the next page.

To install these brackets on a model 700 series tractor, follow these steps:

1.Install a shoulder bolt from your hardware pack on each bracket, securing them with flange lock nuts also included in the hardware pack. Refer to Fig. 4-1.

2.Remove and discard the two screws in the lower frame as seen in Fig. 4-2.

3.Mount the 700 series tractor mounting brackets to your tractor using eight self-tapping hex screws included with your kit by using the pre-drilled holes in your tractor’s frame for the two top mounting bolts and the holes on the lower frame where you previously removed and discarded the screws. See Fig. 4-2.

4.When attaching the hitch bracket assembly to the tractor, secure with the clevis pin and clip pins called out in Fig. 4-2, in addition to the clevis pin used in the hitch plate on the following page.

4

Figure 4-1

Secure bracket using eight 5/16-18 x .750

hex tap screws

Clevis pin used on all
700 series tractors	Discard existing bolts and replace
to further secure the
mounting assembly	with bolts from hardware pack
	Figure 4-2

9