MR9600 User Guide
Introduction
This chapter describes how to install the MR9600 Controller into a CommPlete Communication Server CC9600 chassis. This equipment should only be installed by properly qualified service personnel.
The MR9600 Controller assembly consists of the MR9600 Controller card, an integrated Ethernet concentrator card, and a common front panel. Figure 3 shows the layout of the MR9600 card without the concentrator. The MR9600 assembly plugs into bus connectors on the inside of the CC9600 chassis. Three communications connectors on the concentrator module are accessible from the back of the CC9600 chassis: a
Reset
LEDs
Test
RAM
RAM
U6 |
| U7 |
| U5 |
| U4 |
|
|
|
|
|
|
|
Flash Memory
CPU
Connectors
To back panel config/ debug port
Figure 3. MR9600 Controller card. Ethernet concentrator module not shown.
Installation Procedure
1.Unpack the MR9600 assembly from its packaging, and save the packaging for possible future use. Perform a visual inspection of the MR9600. If you are concerned about the condition of the MR9600, call Technical Support for instructions.
2.Remove the blank controller panel or previous MR9600 controller from the CC9600 chassis. The MR9600 is
3.Holding the MR9600 by its handle and the edges of the bottom panel, place the MR9600 into the open controller slot of the CC9600. Make sure the edges of the MR9600 card mate properly with the plastic guides in the CC9600.
4.Slide the MR9600 into the CC9600 chassis until you feel the MR9600’s connectors fit into the bus connectors at the back of the CC9600.
5.Tighten the MR9600's retaining screws.
6.Turn on the PS9600 power supplies, if they are off.
7.Note the PS9600 LED indicators. If they are not lit, see Chapter 6. If they are lit, proceed with MultiCommManager operation (Refer to the MultiCommManager User Guide).
Note: A
MultiCommManager User Guide for more details on the
8 | CommPlete Communications Server |
