Chapter 4 - Using Your Modem
4.The new password is saved automatically.You now can enter more AT commands or exit the data communications program. The next time you remotely configure the modem you must use the new setup password.
Changing the Remote Escape Character
To increase security, you can change a remote modem’s remote configuration escape character. The remote configuration escape character is stored in register S9. The factory default is 37, which is the ASCII code for the percent character (%). For more information on ASCII codes, refer to Appendix D.
1.Establish a remote configuration link with the remote modem as described in Basic Procedure on the previous page.
2.Type ATS9=n, where n is the ASCII code for the new remote configuration escape character.Then press ENTER.
Caution: Setting S9 to 0 (zero) disables remote configuration
3.To save the new value, type AT&W and press Enter.
4.Type ATO, then Enter to exit remote configuration.
26 |