Chapter 1 – Product Description and Specifications

Safety

General Safety

The modem is designed for and intended to be used in fixed and mobile applications. “Fixed” means that the device is physically secured at one location and is not able to be easily moved to another location. “Mobile” means that the device is designed to be used in other than fixed locations.

Caution: Maintain a separation distance of at least 20 cm (8 inches) is normally maintained between the transmitter’s antenna and the body of the user or nearby persons. The Modem is not designed for or intended to be used in portable applications within 20 cm. (8 inches) of the body of the user.

RF Interference Issues

It is important to follow any special regulations regarding the use of radio equipment due in particular to the possibility of radio frequency, RF, interference. Please follow the safety advice given below carefully.

Switch OFF your Wireless MultiModem when in an aircraft. The use of cellular telephones in an aircraft may endanger the operation of the aircraft, disrupt the cellular network and is illegal. Failure to observe this instruction may lead to suspension or denial of cellular telephone services to the offender, or legal action or both.

Switch OFF your Wireless MultiModem when around gasoline or diesel-fuel pumps and before filling your vehicle with fuel.

Switch OFF your Wireless MultiModem in hospitals and any other place where medical equipment may be in use.

Respect restrictions on the use of radio equipment in fuel depots, chemical plants or where blasting operations are in progress.

There may be a hazard associated with the operation of your Wireless MultiModem close to inadequately protected personal medical devices such as hearing aids and pacemakers. Consult the manufacturers of the medical device to determine if it is adequately protected.

Operation of your Wireless MultiModem close to other electronic equipment may also cause interference if the equipment is inadequately protected. Observe any warning signs and manufacturers’ recommendations.

Installation Instructions and Hazardous Locations Warnings

1.The modems are open devices intended for installation in an ultimate enclosure suitable for the intended application.

2.THIS EQUIPMENT IS SUITABLE FOR USE IN CLASS I, DIVISION 2, GROUPS A, B, C, AND D OR NON- HAZARDOUS LOCATIONS ONLY.

3.“WARNING – Explosion Hazard – Substitution of Components may Impair Suitability for Class I Division 2”.

4.“WARNING – Explosion Hazard – Do not Disconnect Equipment Unless Power has been switched off or the area is known to be Non-Hazardous”.

5.“WARNING – Explosion Hazard - Do not replace the Fuse Unless Power has been switched off or the area is known to be Non-Hazardous”.

6.“WARNING – Do not install or remove SIM card unless power has been switched off or the area is known to be Non-Hazardous”.

Vehicle Safety

Do not use your MultiModem while driving.

Respect national regulations on the use of cellular telephones in vehicles. Road safety always comes first.

If incorrectly installed in a vehicle, the operation of Wireless MultiModem telephone could interfere with the correct functioning of vehicle electronics. To avoid such problems, be sure that qualified personnel have performed the installation. Verification of the protection of vehicle electronics should be part of the installation.

The use of an alert device to operate a vehicle’s lights or horn on public roads is not permitted.

Multi-Tech Systems, Inc. MultiModem GPRS Wireless Modem User Guide

5

Page 5
Image 5
Multi-Tech Systems MTCBA-G-F4 manual General Safety, RF Interference Issues, Vehicle Safety