Multi Tech Equipment MT5634ZBA-V-V92 manual Command +VCID=n Caller ID Selection, Callback Attempts

MultiModemZBA-V-V92 User Guide	4 AT Commands, S-Registers, & Result Codes
Command: +VCID=n Caller ID Selection
Values:	n = 0, 1, or 2
Default:	0
Description:	Enables Caller ID detection and configures the reporting and
	presentation of the Caller ID data that is detected after the first
	ring. The reported data includes the date and time of the call,
	the caller's name and number, and a message. Set S0=2.
+VCID=0	Disables Caller ID
+VCID=1	Enables Caller ID with formatted data
+VCID=2	Enables Caller ID with unformatted data
+VCID=?	Displays the allowed values
+VCID?	Displays the currrent value
Command: +VDR=x, y Distinctive Ring Report
Values:	x = 0, 1 Distinctive Ring report control. See description.
	y = 0–255Minimum ring interval in 100 ms units. See descrip-
	tion.
Default:	0, 0
Description:	Enables reporting of ring cadence information to the DTE and
	specifies the minimum ring cadence that will be reported.
	The report format is one line per silence period and one line per
	ring period. The length of the silence period is in the form
	DROF=number in units of 100 ms<CR><LF>, and the length of
	the ring is in the form DRON=number in units of 100 ms<CR>
	<LF>. The modem may produce a Ring event code after the
	DRON message if enabled by the y parameter. The y parameter
	must be set to a value equal to or smaller than the expected
	ring cadence in order to pass the report to the DTE.
+VDR=0, n/a	Disables Distinctive Ring cadence reporting.
+VDR=1, 0	Enables Distinctive Ring cadence reporting. Other call progress
	result codes (including RING) are reported as normal.
+VDR=1, >0	Enables Distinctive Ring cadence reporting. The RING result
	code is reported after the falling edge of the ring pulse (i.e., after
	the DRON report).
+VDR=?	Displays the allowed values.
+VDR?	Displays the currrent value.
Command: #CBAn	Callback Attempts
Values:	n = 1–255
Default:	4
Description:	Sets the number of callback attempts that are allowed after
	passwords have been exchanged between modems.·
Command: #CBDn Callback Delay
Values:	n = 0–255
Default:	15
Description:	Sets the length of time (in seconds) that the modem waits be-
	fore calling back the remote modem.

37