Multi Tech Equipment MT5634ZBA-V-V92 manual #S x Enter Setup Password, #S= x Store Setup Password

MultiModemZBA-V-V92 User Guide	6 Callback Security
Command: #CBSn Callback Enable/Disable
Values:	n = 0, 1, 2, or 3
Default:	0
Description:	Enables or disables callback security options. When callback
	security is enabled, phone number memory locations 0–4, used
	for quick dialing and DTR dialing, become unavailable and are

replaced by callback security memory locations 0–29. The phone number memory locations and their contents are restored when callback security is disabled.

#CBS0 Disables callback security. With this command, the modem connects as if it did not have callback security. This command can be used only after the setup password has been entered.

#CBS1 Enables local and remote callback security. Local callback security requires that the setup password be entered to use the AT command set. The only AT commands that are available without the setup password are AT, ATI, and AT#Sx. For the remote callback security description, see the #CBS2 description. This command can be used only after the setup password has been entered.

#CBS2 Enables remote callback security only. When remote callback security is enabled, the modem waits for a call, challenges the remote modem, calls back the remote modem, and challenges the remote modem again. Local security is disabled, allowing calls to be made from the modem without entering the setup password. This command can be used only after the setup password has been entered.

#CBS3 Temporarily disables callback security if either #CBS1 or #CBS2 is enabled. Callback security remains disabled until the hangup command (+++ATH) is executed locally or the modem is reset. This command can be used only after the setup password has been entered.

Command:	#Sx Enter Setup Password
Values:	x= password (1–8 characters, case sensitive)
Default:	MTSMODEM
Description:	Enters the password used for callback security and remote
	configuration setup. This command allows the use of all
	callback security commands.

Command:	#S=x Store Setup Password
Values:	x= password (1–8 characters, case sensitive)
Default:	MTSMODEM
Description:	Stores a new password for callback security and remote
	configuration setup.

Command:	&V	Display Current Settings
Values:		n/a
Description:		Displays the modem’s active settings, including the telephone
		numbers stored in nonvolatile memory and the security
		settings, if enabled. If the setup password has been entered,
		the passwords are also displayed.

64