Multiquip DCA-45US1 operation manual DCA-45USI Generator Control Panel

DCA-45USI — GENERATOR CONTROL PANEL

Figure 5. Generator Control Panel

The definitions below describe the controls and functions of the DCA-45USI "Generator Control Panel" (Figure 5).

1.Main Circuit Breaker – This three-pole, 110 amp main breaker is provided to protect the U,V, and W Output Terminal Lugs from overload.

2.AC Ammeter – Indicates the amount of current the load is drawing from the generator per leg selected by the ammeter phase-selector switch.

3.Ammeter Change-Over Switch – This switch allows the AC ammeter to indicate the current flowing to the load connected to any phase of the output terminals, or to be switched off. This switch does not effect the generator output in any fashion, it is for current reading only.

4.Voltmeter Change-Over Switch – This switch allows the AC voltmeter to indicate phase to phase voltage between any two phases of the output terminals or to be switched off.

5.Voltage Regulator Control – Allows ±15% manual adjustment of the generator’s output voltage.

6.Frequency Meter – Indicates the output frequency in hertz (Hz). Normally 60 Hz ±1 Hz .

7.AC Voltmeter – Indicates the output voltage present at the U,V, and W Output Terminal Lugs.

Located behind the generator control panel is the Generator Control Box. This box contains some of the necessary electronic components required to make the generator function.

The Control Box is equipped with the following major components:

zOver-Current Relay

zVoltage Rectifer

zStarter Relay

zEngine Controller (Computer Controlled)

zCurrent Transformer

zVoltage Selector Switch

Remember the overcurrent

NOTErelay monitors the current flowing from the U,V, and W Output Terminal Lugs to the load.

In the event of a short circuit or over current condition, it will automatically trip the 60 amp main breaker.

To restore power to the Output Terminal Panel, press the reset button on the overcurrent relay and place the main circuit breaker in the closed position (ON).

PAGE 22 — DCA-45USI — OPERATION AND PARTS MANUAL (STD) — REV. #2 (04/22/05)