DCA10SPX4/DCA10SPXU4 — GENERATOR
5.The ammeter (Figure 25) will indicate zero amps with no load applied.When a load is applied, the ammeter will indicate the amount of current that the load is drawing from the generator.
8.The generator's
Figure 25. Ammeter (No Load)
Figure 28. Voltmeter
6. Set the Speed Control Switch to the RUN position
(Figure 26).9. Use the voltage adjustment control knob (Figure 29) to increase or decrease the desired voltage
Figure 26. Speed Control Switch (RUN) | Figure 29. Voltage Adjust Control Knob |
|
7.Place the main, GFCI, and aux. (Figure 27) circuit breakers on the control panel in the ON position.
10.Observe the generator's ammeter (Figure 30) and verify it reads the anticipated amount of current with respect to the load. The ammeter will only display a current reading if a load is in use.
Figure 30. Ammeter (Load)
Figure 27. Main, GFCI, and Aux.
Circuit Breakers (ON)
11.The generator will run until manually stopped or an abnormal condition occurs.
PAGE 30 — DCA10SPX4/DCA10SPXU4 — OPERATION AND PARTS MANUAL — REV. #0 (08/05/09)