Multiquip DCA220SSCU 3Ø-480V Uvwo Terminal Output Voltages, 1Ø-480V Uvwo Terminal Output Voltages

OUTPUT TERMINAL PANEL CONNECTIONS

3Ø-480V UVWO Terminal Output Voltages

1.Jumper the voltage change-over board for 480V operation as shown in Figure 23. This configuration uses 6 jumper plates in 3 different positions. Remember there are 2 jumper plates at every position. Every jumper plate must be used.

Figure 23. Voltage Change-Over Board 480V

Configuration

2.Connect the load wires to the UVWO terminals as shown in Figure 24.

Figure 24. UVWO Terminal Lugs 3Ø-480V

Connections

NOTICE

ALWAYS make sure that the connections to the UVWO terminals are secure and tight.The possibility of arcing exists, that could cause a fire.

1Ø-480V UVWO Terminal Output Voltages

1.Make sure the voltage change-over board is jumpered for 480V operation as shown in Figure 23.

2.Connect the load wires to the UVWO terminals as shown in Figure 25.

Figure 25. UVWO Terminal Lugs 1Ø-480V

Connections

1Ø-277V UVWO Terminal Output Voltages

1.Make sure the voltage change-over board is jumpered for 480V operation as shown in Figure 23.

2.Connect the load wires to the UVWO terminals as shown in Figure 26.

Figure 26. UVWO Terminal Lugs 1Ø-277V

Connections

DCA220ssCU/4i 60 hz generator• operation manual — rev. #0 (10/25/12) — page 27