GLOBUG LIGHTING SYSTEM — MAINTENANCE
CAUTION - READ SAFETY GUIDELINES
Before performing any maintenance procedures, be sure to READ the lamp, balloon, and general safety guidelines in this manual. Failure to read and understand these safety guidelines could cause severe equipment damage and bodily harm.
Removing the Lamp/Balloon Assembly
1.Place the lamp/ballon assembly in the STOW position.
2.With a 5 mm allen wrench, loosen the set screw (Figure 23) that secures the lamp to the mast adapter stand.
Figure 23. Removing the Balloon/Lamp
CAUTION - BALLOON ZIPPER SAFETY
DO NOT use excessive force when zipping or unzipping the balloon. The possibility exists of the zipper tearing, which would make the balloon unusable.
2.Unzip the zipper (Figure 24) at the bottom of the balloon and roll the balloon envelope upwards to expose the lamp (Figure 25). Remove the lamp guard to gain access to the lamp. DO NOT use excessive force when
3.Disconnect the lamp power cable as shown in Figure 23, and slide the balloon/lamp forward from the mast adapter stand. Place lamp/balloon assembly on a suitable work bench that is free of dirt, and sharp objects that could damage the balloon.
Removing the Lamp
1. Expose the balloon (Figure 24) by pulling down on the velcro tabs and unzip the protective cover as shown in Figure 19. Next, fold the protective cover into itself and zip. 
Figure 25. Removing the Lamp Guard
3.Push down and hold the lamp holder (spring loaded) away from the lamp (Figure 26). Unscrew the lamp (turn counter- clockwise) from the lamp socket.
Figure 24. Exposing the Balloon | Figure 26. Removing the Lamp |
PAGE 28 — GLOBUG LIGHTING SYSTEM — OPERATION & PARTS MANUAL — REV. #3 (03/22/06)
