GLOBUG LIGHTING SYSTEM — MAINTENANCE

Installation of Winch Cable

1.Route (pass) a new winch cable through the main mast pulley ￿ (Figure 37).

2.Route the winch cable around the upper pulley ￿ of the third mast section from back to front.

3.Next, route the winch cable around the lower pulley ￿ of the third mast section from back to front.

4.Route the winch cable around the upper pulley ￿ of the second mast section from back to front.

5.Route the winch cable through the lower bracket of the third mast section

6.Route the winch cable around the lower pulley ￿ of the second mast from front to back.

7.Continue pulling the cable and slide down the mast, be- ing careful not to activate the cable stop latches.

8.Route the cable around the pulley of the first mast ￿ .

9.Place the second mast into the main (first) mast. Next, place the third mast into the second, and finally place the fourth mast into the third.

CAUTION - Winch Cable Safety Stopper

When placing the second mast into the main mast (first), pinch (squeeze) the pulley and pin with pliers (Figure 38) to hold the stopper (cable latch).This will keep the cable stop latch from being activated.

Figure 38. Bypassing Cable Stop Latch

10.Route the tip of the winch cable (Figure 39) through the eyelet retaining stud. Insert cable retaining screw at top of stud and tighten.

Figure 37. Attaching the Winch Cable

Figure 39. Connecting the Winch Cable to the Winch

PAGE 32 — GLOBUG LIGHTING SYSTEM — OPERATION & PARTS MANUAL — REV. #3 (03/22/06)

Page 32
Image 32
Multiquip GB114BC manual Installation of Winch Cable, Bypassing Cable Stop Latch