page 18 —gb12bw/bs/bp LIgHTINg sYsTeM • operaTIoN aNd parTs MaNuaL — rev. #0 (06/24/13)
setuP (Gb12bW)

TrIpod depLoYMeNT (gb12bw)

1. Place the tripod on a firm level surface so that it will
not slide or turn over. Make sure there is enough space
around the unit for the tripod legs to be deployed.
2. Remove tripod from its carrying case. The tripod legs
are secured by a black velcro strap (Figure 8). Squeeze
both tabs on each side of buckle to unlock strap and
allow tripod legs (Figure 9) to be deployed.
Figure 8. Velcro Strap (Open)
SQUEEZE
VELCRO
STRAP
BUCKLE
TRIPOD
LEGS
Figure 9. Tripod Deployment
3. Next, pull upward on the mast and let the tripod legs
deploy. Once the tripod legs have been fully deployed
make sure the legs are locked by securing the latch.
The latch (Figure 10) has two positions, upper and
lower. Placing the latch in the upper position will provide
1 ft. ( 305 mm) more height.
Figure 10. Securing the Tripod
DEPLOYMENT
LATCH
UPPER
LOWER
MAST