safety information
disconnect any
These devices are intended for operator safety.
Disconnection of these devices can cause
Disconnection of any of
these devices will void all warranties.
attempt service on a running machine.
NOTICE
To prevent the lighting system from overturning,
use in winds that exceed 22 mph (10 m/s).
The lighting system should only be used in temperatures
between 23° to 104°F (-5° to 40° C). Failure to comply
with these operating parameters could cause the lamp
to malfunction and shorten the ballast life.
ALWAYS keep the lighting system in proper running
condition.
Fix damage to lighting system and replace any broken
parts immediately.
ALWAYS store equipment properly when it is not being
used. Equipment should be stored in a clean, dry location
out of the reach of children and unauthorized personnel.
attempt to replace lamp with the power on.
Always unplug the power cord from the generator or
power source when changing the lamp.
ALWAYS allow a suffi cient amount of time for the lamp to
before changing. The possibility exists of severe burns.
use force when installing the lamp. Excessive force
could cause the lamp to break, causing bodily harm.
NOTICE
leave any grease or oil residue on lamp surface
when replacing or removing lamp. This can create hot
spots, reducing the service life of the lamp.
ALWAYS make sure lamp surface is clean and dry.
ALWAYS
replace with MQ recommended type lamp. See
parts section of this manual.
If applicable, ALWAYS
make sure the lamp guard is
installed correctly. deform the lamp guard.
unplug the lamp’s AC power cable during
operation.
ALWAYS have a
to install and
remove lamp or replace any damaged fi xture wiring.
NOTICE
When transporting the tripod lighting system, if
applicable, always place in
and place
tripod in its carrying case.
ALWAYS
remove balloon/lamp assembly from the mast
when transporting lighting system. This will prevent
damage to the bulb due to vibration.
leave the balloon/lamp exposed during transport.
Exposure to excess wind or rain could damage the
balloon’s nylon cover.
ALWAYS
place balloon inside its protective cover during
transport. Be sure the cover is secured tightly around the
balloon/lamp assembly.