Safety Information
do noT expose vibrator motor to rain.
do noT use vibrator motor in damp or wet locations without proper electrical circuits.
do noT immerse the motor part in concrete.
alWayS keep clear of rotating or moving parts while operating the vibrator motor.
never leave the machine unattended while running.
alWayS disconnect the motor from the power source when not in use, before servicing, and when changing fl exible shafting and vibrator heads.
Allow the vibrator motor to cool before servicing. Contact with hot components can
cause serious burns.
Before each use, alWayS check the motor
to make certain that there are no damaged parts and that all parts function properly (such as switch, cord housing). If any damage or malfunctioning parts are found, have them repaired or replaced by an authorized service facility.
NOTICE
Secure forms. Make sure the form work is well made and braced to withstand the stresses made by vibration.
Keep vibrator motor clean for better and safer operation.
alWayS store equipment properly when it is not being used. Equipment should be stored in a clean, dry location out of the reach of children and unauthorized personnel.
Use only factory-authorized replacement parts.
Store idle vibrator motor. When not in use, motor should be stored in a dry, safe storage area.
eleCTriCal SaFeTy
CauTion
Power tools must match the outlet.never modify the plug in any way. do noT use any adapter plugs with earthed (grounded) power tools. Unmodifi ed plugs and matching outlets will reduce risk of electric shock.
Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators.There is an increased risk of electric shock if your body is earthed or grounded.
do noT expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock.
do noT abuse power cord. never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil sharp edges or moving parts.Damaged or entangled cords increase the risk of electric shock.
When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock.
This unit is
When applicable, use a protection wiring device, such as a Ground Fault Circuit Interrupter, for the protection of personnel.
Operate electric motor only at the specifi ed voltage indicated on the nameplate.
do noT spray water onto electric motor.
do noT yank the cord to disconnect it from the receptacle. Grasp the plug itself to disconnect it.
alWayS make sure the ON/OFF switch on the electric motor is in the OFF position when not in use and before inserting the power plug into an AC receptacle.
Before plugging the motor into a power source, alWayS remove any wrenches or other tools from the motor, shaft, and head that were used for assembly.
page 8 — MGX Series • operation and parts manual — rev. #0 (03/26/12)
