STARTUP/SHUTDOWN (ELECTRIC MOTORS)

Start-up (Electric Motor)

CAUTION - Read this Manual before Starting!

Read and fully understand this manual before starting or attempting to operate the saw.

Before starting the saw's electric motor make sure that the Safety, General Information, Inspection and Pre-setup

sections have been completed and understood. DO NOT proceed until the above mentioned sections have been completed.

DANGER - Amputation Hazard

NEVER place hands and fingers near the cutting blade.The possibility exists of severe bodily harm if hands and fingers come in contact with rotating saw blade.

CAUTION - Blade Guard Safety

ALWAYS ensure that the cutting blade has been mounted correctly and that it is raised above the surface you are about to cut.

1.Turn the power ON/OFF switch (Figure 17) to the ON position with the blade away from the material to be cut, the cutting blade should begin to rotate. Before cutting remember to follow all safety rules referenced in this manual.

Figure 17. Power ON/OFF Switch (ON)

2.Avoid overloading the motor when cutting.The electric motors are protected with a manual-reset thermal overload switch that will turn the saw off if the motor is overheated. In the event that the switch is tripped, turn the ON/OFF switch to the OFF position and allow the motor to cool before attempting to restart.

Shutdown Procedure

1.Place the power ON/OFF switch (Figure 18) in the OFF position (down).

Figure 18. Power ON/OFF Switch (OFF)

2.Wait for the cutting blade to stop rotating.

3.Disconnect the saw's AC power cord from the power source.

CAUTION - Leaving the Saw Unattended

NEVER leave the saw connected to a power source when unattended. This will prevent accidental starting and potential injury.

4.Using a soft cloth, clean any excess debris or residue that may have accumulated on the saw.

5.Store saw in a clean dry location where it will be out of the reach of children.

MQ MP2 SERIES SAW — OPERATION MANUAL — REV. #0 (01/26/09) — PAGE 23

Page 23
Image 23
Multiquip MP24, MP275E3, MP25E3, MP25E1 STARTUP/SHUTDOWN Electric Motors, Start-up Electric Motor, Shutdown Procedure