Multiquip PS403016 Fuel Filter 200 Hours, Lubrication, Prevent Crush Injury, Engine Tune-Up

MQ PS4030 SAW — MAINTENANCE

Fuel Filter (200 Hours)

■Replace the engine fuel filter (Figure 41) every 500 hours. Refer to your engine manual for specific details to perform this operation.

1

Lubrication

This saw has many service-saving features, including fully enclosed oil bath lubricated Blade Shaft bearings that require no daily lubrication.

This saw has 5 grease fittings.

Grease these fittings every 125 hours of operation with a premium grade waterproof E.P. (extreme pressure) grease.

WARNING

Prevent Crush Injury!

When necessary, ensure the saw is securely placed on blocks before servicing.

Figure 41. Fuel Filter Removal
Oil And Fuel Lines
■ Check the oil and fuel lines and connections regularly for	1
leaks or damage. Repair or replace as necessary.

Engine Tune-Up

■See your engine manual for specific information on tuning up your engine.

	See the engine manual supplied
NOTE	with your machine for appropriate
	engine maintenance schedule	2

and troubleshooting guide for	2
problems.

At the front of the book (Page 9) there is a “Daily Pre-Operation Checklist”. Make copies of this checklist and use it on a daily basis.

Disconnect negative (ground) battery cable and secure away before attempting any service or maintenance on the saw.

1. Front Axle Pivot Bearing

2. Hydraulic Lift Cylinder

Figure 42. Grease Fittings

PAGE 42 — MQ PS4030 SAW • OPERATION MANUAL — REV. #0 (02/29/08)