Multiquip PS403020 MQ PS4030 SAW Maintenance, Replacing the Battery, Remove rear access panel

MQ PS4030 SAW — MAINTENANCE

Replacing the Battery Removable Guards and Access Panels

Figure 44. Battery Location

1.Remove rear access panel.

2.Disconnect both negative battery cables first, then disconnect both positive battery cables to prevent arcing.

3.Remove top battery retainer clip, (Item A, Figure 45).

4.Remove lower battery retainer, (Item B, Figure 45).

5.Carefully slide battery out of tray. Dispose of properly in accordance with ordinances and regulations in your area.

6.Install new battery in tray.

7.Install lower battery retainer. Push retainer tightly against battery and tighten bolt.

8.Install top battery retainer clip.

9.Re-connect both positive cables first, then both negative cables to prevent arcing.

For ease of service access, the guards and access panels shown in Fig. 46 are removable.

3

4

2

5

6

1

1.Blade Guard

2.Rear Access Panel

3.Console Access Panel

4.Belt Guard

5.Flange Guard

6.Engine Guard

Figure 46. Guards & Panels

WARNING

Replace guards and panels prior to starting the engine.

A

B

Figure 45. Battery Tray and Retainer Clips

PAGE 44 — MQ PS4030 SAW • OPERATION MANUAL — REV. #0 (02/29/08)