1. Engine – The MQ R2000H
2.SteeringWheel — Use this wheel to steer the roller.
3.Parking Break Lever — Pull the lever upward to set the parking break. To release the parking break, press and hold the button on top of the lever and push lever downward.
4.Transmission Control Lever — Push the lever forward to make the roller travel in a forward direction, pull the lever backward to make the roller travel in a reverse direction. Maximum travel speed is 5.6 MPH (9.0 KPH). Center position is neutral, no travel.
5.Documentation Box — Maintain and store at all times Operation, Parts, and Engine manuals in this box.
6.Operator's Seat — A contoured seat that provides visibility of both front rear drum edges during operation. NEVER! start the roller unless seated in the operator's seat.
7.Water Tank/Cap — Remove filler cap and fill with clean fresh water.Water tank capacity is 21 gallons (79.5 liters). If water level is low, add water as necessary.
8.Rear Lifting Point – Attach a crane or suitable lifting device to this point when lifting of the roller is required.
9.Rear Scrapper – This adjustable rear scrapper blade helps prevent the buildup of material between the drum and frame.
10.Rear Roller – This roller is a
11.Front Lifting Point – Attach a crane or suitable lifting device to this point when lifting of the roller is required.
12.Front Scrapper – This adjustable rear scrapper blade helps prevent the buildup of material between the drum and frame.
13.Front Roller Water Plug – Remove this plug to add water (ballast) to the front drum. This plug is located on each side of the split front roller.
14.Front Roller Zerk Fitting – Grease this fitting as recommended in the maintenance section of this manual.
15.Steering Zerk Fitting – Grease this fitting as recommended in the maintenance section of this manual.
R2000H — ROLLER COMPONENTS
16.Access Panel – Lift this
A.Transmission – This roller uses a hydrostatic pump which provides hydraulic pressure to the hydraulic drive system. Fill the pump reservoir with hydrostatic transmission fluid. Fill with Mobil 300, GM Dextron B or Ford
Free Wheel Engagement Pin
The hydrostatic transmission is equipped with a free wheel engagement pin, which, when actuated, allows the oil to circulate freely within the roller, thereby permitting the roller to be moved without the engine running. This engagement pin is only to be used in the event the roller is disabled.
This pin is located on the side of the hydrostatic transmission underneath the acess cover.It is actuated by pushing the pin inward and placing the locking clip over the pin to keep it in place.
B.Battery – Provides +12VDC to the electrical system. Replace only with recommended type battery, see specification Table 1.
17.Sprinkler Valve Lever – A gravity feed spray bar is provided on the front and rear of the roller for the wetting of the roll for asphalt pavement. Pull upward on the lever to start the flow of water to the gravity feed system. Push the lever downward to stop the flow of water.
18.Front Roller – This roller is a split
19.Rear Roller Water Plug – Remove this plug to add water (ballast) to the rear drum. This plug is located on the
Tie-Down Transport Points –
Attach a chain or suitable
NOTE device to these points when transporting of the roller is required.
R2000H
