R2000H — OPERATION
Water Sprinklers Control
1.If the application requires the wetting of a surface, open the water valve located at the bottom of the roller floor (Figure 16) to spread the proper amount of water onto the roller drum at the desired rate that will wet both the front and rear rollers.
Figure 16.Water Sprinkler Valve (ON)
Normal Shut-Down
1.Place the engine throttle lever in the idle position. Let the engine idle for
2.If the water valve is open, close it (Figure17)
Figure 17.Water Sprinkler Valve (OFF)
3.Place the transmission lever (Figure 18) in the neutral position.
Figure 18.Transmission Control Lever (Neutral)
4.Placetheparkingbrakelever(Figure19)intheset position. This will lock the rear roller drum in place, and prevent the rollerfrommoving.Whenevertheoperator'sseatisvacated, place the transmission lever in neutral, and set the parking brake
Figure 19. Parking Brake Lever (Set)
5.Turn the ignition key (Figure X) to the OFF position remove key. Store key in a safe place.
Figure 20. Ignition Switch (OFF)
6.Place the engine fuel valve lever (Figure 20) in the OFF position.
7.To prevent the roller from moving, place chock blocks under each roller drum
8.Clean the entire roller with warm water and mild soap. Pay close attention to the scrapper bar and spray bar holes, making sure that no dirt or debris is present. Dirt and debris can cause the sprinkler system to get clogged.
Emergency Shut-Down
1.Turn the ignition key (Figure20) to the OFF position.
2.Place the engine fuel valve lever (Figure 11) in the OFF position.
R2000H
