Multiquip manual R2000H - ENGINE COMPONENTS, Danger, Engine Controls and Components

R2000H — ENGINE COMPONENTS

Figure 5. Engine Controls and Components

INITIAL SERVICING (ENGINE)

The engine (Figure 5) must be checked for proper lubrication and filled with fuel prior to operation. Refer to the manufacturer's engine manual for instructions and details of operation and servicing.

1. Fuel Filler Cap/Fuel tank – Remove this cap to add unleaded gasoline to the fuel tank. Make sure cap is tightened securely. DO NOT over fill. Fuel tank capacity is

1.59gallons (6.0 liters). Use unleaded gasoline. For additional information refer to Honda engine owner's manual.

DANGER

Adding fuel to the tank should be done only when theengine isstopped and hashadanopportunity to cool down. In the event of a fuel spill, DO NOT

attempt to start the engine until the fuel residue has been completely wiped up, and the area surrounding the engine is dry.

2. Throttle Lever – Used to adjust engine RPM speed (lever advanced forward SLOW, lever back toward operator FAST).

3. Engine ON/OFF Switch – ON position permits engine

	starting, OFF position stops engine operations.
4.	Recoil Starter (pull rope) – Manual-starting method. Pull
	the starter grip until resistance is felt, then pull briskly and
	smoothly.
5.	FuelValve Lever – OPEN to let fuel flow, CLOSE to stop
	the flow of fuel.

6.	Choke Lever – Used in the starting of a cold engine, or in
	cold weather conditions. The choke enriches the fuel
	mixture.
7.	Air Cleaner – Prevents dirt and other debris from entering
	the air intake system. Remove wing-nut on top of air filter
	cannister to gain access to filter element.
		Operating the engine without an air
	NOTE	filter, with a damaged air filter, or a
		filter in need of replacement will allow
		dirt to enter the engine, causing rapid
		engine wear.
8.	Spark Plug – Provides spark to the ignition system. Set
	spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch) Clean
	spark plug once a week.
9.	Muffler – Used to reduce noise and emissions.

WARNING

Engine components can generate extreme heat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER operate the engine with the muffler removed.

10. Ignition Switch– Use this switch to start and stop the engine.

11. Circuit Breaker– Protects the battery charging circuit. See Honda owner's manual for additional information.

PAGE 20 —R2000H RIDE-ON STATIC ROLLER — OPERATION & PARTS MANUAL — REV. #4 (07/24/08)