CAUTION
NEVER operate the roller in a confined area or enclosed area structure that does not provide ample free flow of air.
ALWAYS wear approved eye and hearing protection before operating the roller.
NEVER place hands or feet inside the guard rings while the engine is running. ALWAYS shut the engine down before performing any kind of maintenance service on the roller.
Before Starting
1.Read safety instructions at the beginning of manual.
2.Clean the roller, removing dirt and dust, particularly the air filter and carburetor.
3.Check theairfilter for dirtanddust. Ifairfilterisdirty,replace air filter with a new one as required.
4.Check carburetor for external dirt and dust. Clean with dry compressedair.
5.Check fastening nuts and bolts for tightness.
Engine Oil Check
1.To check the engine oillevel, placethe roller on secure level ground with the engine stopped.
2.Remove the filler dipstick from the engine oil filler hole (Figure 6) and wipe it clean.
Figure 6. Engine Oil Dipstick (Removal)
R2000H — INSPECTION
3.Insertandremovethedipstickwithoutscrewingitintothefiller neck. Check the oil level shown on the dipstick.
4.If the oil level is low (Figure 7), fill to the edge of the oil filler hole with the recommended oil type (Table 4). Maximum oil
capacity is 400 cc.
Reference manufacturer engine
NOTE manual for specific servicing instructions.
Figure 7 Engine Oil Dipstick (Oil Level)
Table 4. Oil Type
Season | Temperature | Oil Type |
|
|
|
Summer | 25°C or Higher | SAE |
|
|
|
Spring/Fall | 25°C~10°C | SAE |
|
|
|
Winter | 0°C or Lower | SAE |
|
|
|
Explosive Fuel
CAUTION
Motor fuels are highly flammable and can be dangerous if mishandled. DO NOT smoke while refueling. DO NOT attempt to refuel the roller if the engine is hot! or running.
Fuel Check
1.Remove the gasoline cap located on top of fuel tank.
2.Visuallyinspecttoseeiffuellevelislow. Iffuelislow,replenish with unleaded fuel.
3.When refueling, be sure to use a strainer for filtration. DO NOT
R2000H
