RX 1510-C/-I/-CI
– 55 –
1 2 3 649875 N

SI

4.4.4 Infrared transmitter
The infrared control is used to operate the machine with infrared control. Solar
cells supply the electrical current. Therefore, no batteries are required to operate
the infrared transmitter. The infrared transmitter is equipped with freely selectable
addresses, in order to transmit the transmitter signal. The machine controller
must be set to the same address as the infrared transmitter. The thumb wheel
is located under the square plug SI . This can be screwed off with a screwdriver.
The addresses can be set with a small screwdriver by turning the arrow in the
middle. If several machines are operating within the same work area, then the
machines must be used with differently set addresses. Up to four addresses are
available. Therefore, up to 4 machines can be operated by infrared at the same
time within the same work area. The addresses 6 to 9 are without function.
Pos Function
1Fast gear on/off
2Driving forward
3 Steering angle left
4large amplitude
5Driving backwards
6Steering angle right
7low amplitude
8Start
9Machine off
NNeutral position
Display and operating elements: