Multiquip RX 1510-C/-I/-CI - page 64

RX 1510-C/-I/-CI
– 64 –
SI
SM
NOTE

The addresses at the transmitter and receiver must correspond.Transmitter and
receiver are factory set to address 5.

(only for machines with infrared control)
Setting the transmitter address on the machine controller:
1) Fold the operating panel back.
2) Remove the plug SM from the machine controller with a screwdriver
entfernen.
3) Set in the required address by turning the arrow with a screwdriver.
Setting the transmitter address on the infrared control:
Remove the plug „SI“ from the infrared control with a screwdriver entfernen.
• Set the same address as on the machine controller by turning the arrow with
a screwdriver.
Start-up