Multitech MT5600ZDXV manual Command Ds Dial Zdxv only

		User Guide
Command: Ds	Dial	{ ZDXV only }
Values:	s = dial string (phone number and dial modifiers)
Default:	none
Description:	Dial telephone	number s, where s may up to 40

characters. Dial string modifiers:

0-9DTMF digits 0 to 9

* The "star" digit (tone dialing only)

# The "gate" digit or “pound sign” (tone dialing only)

A-DA, B, C, and D DTMF digits. Country specific; some countries may prohibit these digits.

LRedial last number. (Must be placed immediately

after ATD.)

PPulse-dial following numbers in command. T Tone-dial following numbers in command

V Switch to speakerphone mode and dial the following number. Use ATH command to hang up.

W Wait for a new dial tone before continuing to dial. (X0, X1, X3, or X4 must be selected.)

S Dial a telephone number previously stored using the &Zn=x command (see &Zn=x command for further information). The range of n is 0-3.

, Pause during dialing for time set in register S8.

; Return to command mode after dialing. (Place at end of dial string.)

! Hook flash. Causes the modem to go on-hook for one-half second, then off-hook again (time speci- fied in S29).

@ Wait for quiet answer. Causes modem to wait for a ringback, then 5 seconds of silence, before processing next part of command. If silence is not detected, the modem returns a NO ANSWER code. $ Wait for credit card dialing tone before continuing with the dial string (wait contingent on S7 setting).

^ Toggles data calling tone enable/disable: applicable to current dial attempt.

35