46
Models MT5600ZDX & ZDXV
Command: \BnTransmit Break to Remote
Values: n =\B1-\B9
Default: \B3
Description: \B3 Break length in 100 ms units (non-error correction
mode).
In non-error correction mode, the modem will
transmit a break signal to the remote modem with
a length in multiples of 100 ms according to param-
eter specified. The command works in conjunction
with the \K command. In error correction mode,
the modem will signal a break through the active
error correction protocol, giving no indication of the
length.
*: When the modem receives a break from the remote modem, break is
passed to the DTE as follows: In non-error correction mode direct, the break
length is passed; in non-error correction mode normal and in error correction
mode, a 300 ms break is passed.
Command: \KnSet Break Control
Values: n = 0, 1, 2, 3, 4 or 5
Default: 5
Description: Controls the response of the modem to a break
received from the DTE or the remote modem or the
\B command according to the parameter specified.
The response is different in three separate command
states.
*The first state is where the modem receives a break from the DTE when
the modem is operating in data transfer mode:
\K0 Enter on-line command mode, no break sent to the
remote modem.
\K1 Clear data buffers and send break to remote mo-
dem.
\K2 Same as \K0.
\K3 Send break to remote modem immediately.
\K4 Same as \K0.
\K5 Send break to remote modem in sequence with
transmitted data.