Multitech MT5600ZDXV manual Register Unit Range Default Description S38

Models MT5600ZDX & ZDXV

If N0 command is active, S37 = 10 updates the +MS command subparameters to reflect +MS = 10,1,300,12000.

IF N1 command is active, S37 = 10 updates the +MS command subparameters to reflect +MS = 10,0,12000,12000.

S37 is not updated by the +MS command.

Use of the +MS command is recommended instead of the Nn and S37 = x commands. Nn and S37 = x commands are supported for compatibility with existing communications software.

Bits 0-4 Desired line connection speed. If an invalid number is entered, the number is accepted into the register, but S37 will act as if the default value has been entered.

0 = Attempt automode connection. If N0 is active, connection is attempted at the most recently sensed DTE speed (+MS command settings are updated to the most appropriate values). If N1 is active, connection is attempted at the highest possible speed (+MS settings are updated to 11,1,300,2880 to reflect V.34, automode, 300 bps minimum speed, and 28800 bps maximum speed)--Default.

Register	Unit	Range	Default	Description
S38	decimal	0–255	20	This register specifies the delay
				between the modem’s receipt
				of the H command to disconnect
				(or ON-to-OFF transition of DTR
				if the modem is programmed to
				follow the signal), and the dis-
				connect operation. Applicable
				to error-correction connection
				only. If S38 is set to a value
				between 0 and 254, the waits
				for the remote modem to ac-
				knowledge all data in the modem
				buffer before disconnecting. If
				S38 is set to 255, the modem
				does not time-out and continues
				to attempt to deliver data in the
				buffer until the connection is lost
				or the data is delivered.

58