LevelOne GSW-2692 manual Radius Client Commands Function Mode

Authentication Commands 4

authentication is attempted on the TACACS+ server. If the TACACS+ server is not available, the local user name and password is checked.

Example

Console(config)#authentication enable radius

Console(config)#

Related Commands

enable password - sets the password for changing command modes (4-27)

RADIUS Client

Remote Authentication Dial-in User Service (RADIUS) is a logon authentication protocol that uses software running on a central server to control access to RADIUS-aware devices on the network. An authentication server contains a database of multiple user name/password pairs with associated privilege levels for each user or group that require management access to a switch.

Table 4-29 RADIUS Client Commands

Command	Function	Mode	Page
radius-server host	Specifies the RADIUS server	GC	4-74
radius-server port	Sets the RADIUS server network port	GC	4-74
radius-server key	Sets the RADIUS encryption key	GC	4-74
radius-server retransmit	Sets the number of retries	GC	4-75
radius-server timeout	Sets the interval between sending authentication requests	GC	4-75
show radius-server	Shows the current RADIUS settings	PE	4-76

radius-server host

This command specifies primary and backup RADIUS servers and authentication parameters that apply to each server. Use the no form to restore the default values.

Syntax

[no] radius-serverindex host {host_ip_address host_alias} [auth-portauth_port] [timeout timeout] [retransmit retransmit] [key key]

•index - Allows you to specify up to five servers. These servers are queried in sequence until a server responds or the retransmit period expires.

•host_ip_address - IP address of server.

•host_alias - Symbolic name of server. (Maximum length: 20 characters)

•port_number - RADIUS server UDP port used for authentication messages. (Range: 1-65535)

•timeout - Number of seconds the switch waits for a reply before resending a request. (Range: 1-65535)

4-73