LevelOne GSW-2692 manual Enabling Lacp on Selected Ports, 124

3 Configuring the Switch

CLI – This example creates trunk 2 with ports 1 and 2. Just connect these ports to two static trunk ports on another switch to form a trunk.

Console(config)#interface	port-channel 2	4-108
Console(config-if)#exit
Console(config)#interface	ethernet 1/1	4-108
Console(config-if)#channel-group 2		4-124
Console(config-if)#exit
Console(config)#interface	ethernet 1/2
Console(config-if)#channel-group 2
Console(config-if)#end
Console#show interfaces status port-channel 2		4-115
Information of Trunk 2
Basic information:
Port type:	100TX
Mac address:	00-90-CC-12-34-84
Configuration:
Name:
Port admin:	Up
Speed-duplex:	Auto
Capabilities:	10half, 10full, 100half, 100full
Flow control:	Disabled
Port security:	Disabled
Max MAC count:	0
Current status:
Created by:	User
Link status:	Up
Port operation status:	Up
Operation speed-duplex: 100full
Flow control type:	None
Member Ports: Eth1/1, Eth1/2,
Console#

Enabling LACP on Selected Ports

Command Usage

•To avoid creating a loop in the network, be sure you enable LACP before connecting the ports, and also disconnect the ports before disabling LACP.

•If the target switch has also enabled LACP on the connected ports, the trunk will be activated automatically.

•A trunk formed with another switch using LACP will automatically be assigned the next available trunk ID.

	dynamically
	enabled
	}
active	backup
links	link
	}
	configured
	members

•If more than eight ports attached to the same

target switch have LACP enabled, the additional ports will be placed in standby mode, and will only be enabled if one of the active links fails.

•All ports on both ends of an LACP trunk must be configured for full duplex, either by forced mode or auto-negotiation.

•Trunks dynamically established through LACP will also be shown in the Member List on the Trunk Membership menu (see page 3-69).

3-70