LevelOne GSW-2692 Adding Static Members to VLANs Vlan Index, CLI This example creates a new Vlan

3 Configuring the Switch

CLI – This example creates a new VLAN.

Console(config)#vlan database		4-149
Console(config-vlan)#vlan 2 name R&D media ethernet state active		4-150
Console(config-vlan)#end
Console#show vlan		4-157
Vlan ID:	1
Type:	Static
Name:	DefaultVlan
Status:	Active
Ports/Port Channel:	Eth1/ 1(S) Eth1/ 2(S) Eth1/ 3(S) Eth1/ 4(S) Eth1/ 5(S)
	Eth1/ 6(S) Eth1/ 7(S) Eth1/ 8(S) Eth1/ 9(S) Eth1/10(S)
	Eth1/11(S) Eth1/12(S) Eth1/13(S) Eth1/14(S) Eth1/15(S)
	Eth1/16(S) Eth1/17(S) Eth1/18(S) Eth1/19(S) Eth1/20(S)
	Eth1/21(S) Eth1/22(S) Eth1/23(S) Eth1/24(S) Eth1/25(S)
	Eth1/26(S)
Vlan ID:	2
Type:	Static
Name:	R&D
Status:	Active
Ports/Port Channel:

Console#

Adding Static Members to VLANs (VLAN Index)

Use the VLAN Static Table to configure port members for the selected VLAN index. Assign ports as tagged if they are connected to 802.1Q VLAN compliant devices, or untagged they are not connected to any VLAN-aware devices. Or configure a port as forbidden to prevent the switch from automatically adding it to a VLAN via the GVRP protocol.

Notes: 1. You can also use the VLAN Static Membership by Port page to configure VLAN groups based on the port index (page 3-114). However, note that this configuration page can only add ports to a VLAN as tagged members.

2.VLAN 1 is the default untagged VLAN containing all ports on the switch, and can only be modified by first reassigning the default port VLAN ID as described under “Configuring VLAN Behavior for Interfaces” on page 3-115.

Command Attributes

•VLAN – ID of configured VLAN (1-4094).

•Name – Name of the VLAN (1 to 32 characters).

•Status – Enables or disables the specified VLAN.

-Enable: VLAN is operational.

-Disable: VLAN is suspended; i.e., does not pass packets.

•Port – Port identifier.

3-112