LevelOne GSW-2692 manual IP ACLs, Access-list ip, Access Control Lists Command Groups Function

4 Command Line Interface

Table 4-33 Access Control Lists

Command Groups	Function	Page
IP ACLs	Configures ACLs based on IP addresses, TCP/UDP port number,	4-90
	protocol type, and TCP control code
MAC ACLs	Configures ACLs based on hardware addresses, packet format, and	4-97
	Ethernet type
ACL Information	Displays ACLs and associated rules; shows ACLs assigned to each port	4-102

IP ACLs

Table 4-34 IP ACLs

Command	Function	Mode	Page
access-list ip	Creates an IP ACL and enters configuration mode	GC	4-90
permit, deny	Filters packets matching a specified source IP address	STD-ACL	4-91
permit, deny	Filters packets meeting the specified criteria, including	EXT-ACL	4-92
	source and destination IP address, TCP/UDP port number,
	protocol type, and TCP control code
show ip access-list	Displays the rules for configured IP ACLs	PE	4-94
ip access-group	Adds a port to an IP ACL	IC	4-94
show ip access-group	Shows port assignments for IP ACLs	PE	4-94
map access-list ip	Sets the CoS value and corresponding output queue for	IC	4-95
	packets matching an ACL rule
show map access-list ip	Shows CoS value mapped to an access list for an interface	PE	4-96

access-list ip

This command adds an IP access list and enters configuration mode for standard or extended IP ACLs. Use the no form to remove the specified ACL.

Syntax

[no] access-list ip {standard extended} acl_name

•standard – Specifies an ACL that filters packets based on the source IP address.

•extended – Specifies an ACL that filters packets based on the source or destination IP address, and other more specific criteria.

•acl_name – Name of the ACL. (Maximum length: 16 characters)

Default Setting

None

Command Mode

Global Configuration

4-90