LevelOne GSW-2692 manual Priority Commands Layer, Priority Commands Command Groups Function

4 Command Line Interface

Related Commands

garp timer (4-166)

Priority Commands

The commands described in this section allow you to specify which data packets have greater precedence when traffic is buffered in the switch due to congestion. This switch supports CoS with four priority queues for each port. Data packets in a port’s high-priority queue will be transmitted before those in the lower-priority queues. You can set the default priority for each interface, the relative weight of each queue, and the mapping of frame priority tags to the switch’s priority queues.

Table 4-57 Priority Commands

Command Groups	Function	Page
Priority (Layer 2)	Configures default priority for untagged frames, sets queue weights,	4-168
	and maps class of service tags to hardware queues
Priority (Layer 3 and 4)	Maps TCP ports, IP precedence tags, or IP DSCP tags to class of	4-174
	service values

Priority Commands (Layer 2)

Table 4-58 Priority Commands (Layer 2)

Command	Function	Mode	Page
queue mode	Sets the queue mode to strict priority or Weighted	GC	4-169
	Round-Robin (WRR)
switchport priority default	Sets a port priority for incoming untagged frames	IC	4-169
queue bandwidth	Assigns round-robin weights to the priority queues	GC	4-170
queue cos map	Assigns class-of-service values to the priority queues	IC	4-171
show queue mode	Shows the current queue mode	PE	4-172
show queue bandwidth	Shows round-robin weights assigned to the priority queues	PE	4-172
show queue cos-map	Shows the class-of-service map	PE	4-173
show interfaces switchport	Displays the administrative and operational status of an	PE	4-117
	interface

4-168