LevelOne GSW-2692 manual Switchport mode, Switchport acceptable-frame-types, All frame types

4 Command Line Interface

switchport mode

This command configures the VLAN membership mode for a port. Use the no form to restore the default.

Syntax

switchport mode {trunk hybrid private-vlan}no switchport mode

•trunk - Specifies a port as an end-point for a VLAN trunk. A trunk is a direct link between two switches, so the port transmits tagged frames that identify the source VLAN. Note that frames belonging to the port’s default VLAN (i.e., associated with the PVID) are also transmitted as tagged frames.

•hybrid - Specifies a hybrid VLAN interface. The port may transmit tagged or untagged frames.

•private-vlan- For an explanation of this command see “switchport mode private-vlan” on page 4-161.

Default Setting

All ports are in hybrid mode with the PVID set to VLAN 1.

Command Mode

Interface Configuration (Ethernet, Port Channel)

Example

The following shows how to set the configuration mode to port 1, and then set the switchport mode to hybrid:

Console(config)#interface ethernet 1/1

Console(config-if)#switchport mode hybrid

Console(config-if)#

Related Commands

switchport acceptable-frame-types (4-152)

switchport acceptable-frame-types

This command configures the acceptable frame types for a port. Use the no form to restore the default.

Syntax

switchport acceptable-frame-types {all tagged} no switchport acceptable-frame-types

•all - The port accepts all frames, tagged or untagged.

•tagged - The port only receives tagged frames.

Default Setting

All frame types

4-152