LevelOne GSW-2692 manual Snmp-server host, Host Address None Snmp Version

SNMP Commands 4

Related Commands

snmp-server contact (4-104)

snmp-server host

This command specifies the recipient of a Simple Network Management Protocol notification operation. Use the no form to remove the specified host.

Syntax

snmp-server host host-addrcommunity-string[version {1 2c}] no snmp-server host host-addr

•host-addr- Internet address of the host (the targeted recipient). (Maximum host addresses: 5 trap destination IP address entries)

•community-string- Password-like community string sent with the notification operation. Although you can set this string using the snmp-server host command by itself, we recommend that you define this string using the snmp-server community command prior to using the snmp-server host command. (Maximum length: 32 characters)

•version - Specifies whether to send notifications as SNMP v1 or v2c traps. (Range: 1, 2c; Default: 1)

Default Setting

Host Address: None

SNMP Version: 1

Command Mode

Global Configuration

Command Usage

•If you do not enter an snmp-server host command, no notifications are sent. In order to configure the switch to send SNMP notifications, you must enter at least one snmp-server host command. In order to enable multiple hosts, you must issue a separate snmp-server host command for each host.

•The snmp-server host command is used in conjunction with the snmp-server enable traps command. Use the snmp-server enable traps command to specify which SNMP notifications are sent globally. For a host to receive notifications, at least one snmp-server enable traps command and the snmp-server host command for that host must be enabled.

•Some notification types cannot be controlled with the snmp-server enable traps command. For example, some notification types are always enabled.

•The switch can send SNMP version 1 or version 2c notifications to a host IP address, depending on the SNMP version that the management station supports. If the snmp-server host command does not specify the SNMP version, the default is to send SNMP version 1 notifications.

4-105