LevelOne GSW-2692 manual IP Filter

3 Configuring the Switch

•IP address can be configured for SNMP, web and Telnet access respectively. Each of these groups can include up to five different sets of addresses, either individual addresses or address ranges.

•When entering addresses for the same group (i.e., SNMP, web or Telnet), the switch will not accept overlapping address ranges. When entering addresses for different groups, the switch will accept overlapping address ranges.

•You cannot delete an individual address from a specified range. You must delete the entire range, and reenter the addresses.

•You can delete an address range just by specifying the start address, or by specifying both the start address and end address.

Command Attributes

•Web IP Filter – Configures IP address(es) for the web group.

•SNMP IP Filter – Configures IP address(es) for the SNMP group.

•Telnet IP Filter – Configures IP address(es) for the Telnet group.

•IP Filter List – IP address which are allowed management access to this interface.

•Start IP Address – A single IP address, or the starting address of a range.

•End IP Address – The end address of a range.

•Add/Remove Filtering Entry – Adds/removes an IP address from the list.

Web – Click Security, IP Filter. Enter the IP addresses or range of addresses that are allowed management access to an interface, and click Add IP Filtering Entry.

Figure 3-34 IP Filter

3-56