the room thermostat is connected and turn the room thermostat up above room temperature to start the combustion blower fan to run the Munchkin. The Munchkin will now run its pre- purge cycle, then begin running, which will be indicated by the Green light illuminating under “Flame On” in your display.
DANGER
If you do not follow these instructions exactly, a fire or explosion may
result, causing property damage, personal injury or loss of life.
C. LIGHTING INSTRUCTIONS
FOR YOUR OWN SAFETY READ BEFORE OPERATING
1.This appliance does not have pilot. It is equipped with an ignition device which automatical- ly lights the burner. Do not try to light the burner by hand.
2.BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor's phone. Follow the gas suppliers' instructions.
•If you cannot reach your gas supplier, call the fire department.
3.Turn on gas shutoff valve (located inside of the Heater) so that the handle is aligned with the gas pipe. If the handle will not turn by hand, don't try to repair it, call a qualified service tech- nician. Force or attempted repair may result in a fire or explosion.
4.Do not use this appliance if any part has been under water. Immediately call a qualified serv- ice technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
5.The Munchkin Boiler shall be installed so the gas ignition system components are protected from water (dripping, spraying, rain, etc.) during appliance operation and service (circulator replacement, condensate trap, control replacement, etc.)
D. OPERATING INSTRUCTIONS
1.STOP! Read the safety information in Part 6.
2.Set the thermostat to the lowest setting.
3.Turn off all electric power to the appliance.
4.This appliance is equipped with an ignition device which automatically lights the burner. Do not try to light the burner by hand.
5.Remove front cover.
6.Turn gas shutoff valve to “off”.
7.Wait five (5) minutes to clear out any gas. If you then smell gas, STOP! Follow Part 6, Section B/Lighting Instructions in the safety information. If you don't smell gas, go to the next step.
8.Turn the gas shutoff valve counter clockwise to “on”. The handle will be horizontal.
9.Replace the Front Cover.
10.Turn on all electric power to appliance.
11.Set the thermostat to the desired setting.
35
