Murray 1737921, 1695720 manual After Each USE, Cable Adjustment

								MAINTENANCE
		SERVICE RECOMMENDATIONS
PROCEDURE		FIRST	BEFORE	OFTEN	EVERY	EVERY	EVERY	BEGINNING	BEFORE
		2	EACH		5	10	25	EACH
									STORAGE
		HOURS	USE		HOURS	HOURS	HOURS	SEASON
	Tighten all Screws and	✓		✓				✓
	Nuts
	Check Traction Clutch
	Cable Adjustment (See	✓						✓
	Cable Adjustment)
	Check Auger Clutch
	Cable Adjustment (See	✓				✓		✓
SNOW THROWER	Cable Adjustment)
	Adjust Drive Belts	✓					✓	✓
	Lubricate Chains and Hex							✓	✓
	Shaft
	Lubricate Auger Shaft
	(See Shear Pin Replace-					✓			✓
	ment)
	Lubricate Free-Hand	✓				✓		✓
	Linkage
ENGINE	Oil, Check		✓		✓			✓
	Oil, Change	✓					✓	✓

NOTE: The warranty on this snow thrower does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, operator must maintain snow thrower as instructed in this manual.

The above Service Recommendations are supplied to assist the opera- tor to properly maintain the snow thrower. This is a check list only. Adjust- ment referred to will be found in the MAINTENANCE section of this manual.

AFTER EACH USE

1.Check for any loose or damaged parts.

2.Tighten any loose fasteners.

3.Check and maintain the auger.

4.After each use, remove all snow and slush off the snow thrower to prevent freezing of auger or controls.

5.Check controls to make sure they are functioning properly.

6.If any parts are worn or damaged, replace immediately.

19