Configuration – Save or Reset
The Configuration section of web management gives an administrator the ability to save a running configuration into the NVRAM. This step is needed in order for the switch to remember any changes after a power cycle.
The “Save” button will save all current changes to the configuration for use after the next power cycle.
Note: The current configuration will also be saved to the dongle when connected.
The “Reset” button will discard all unsaved changes , reset the switch and load the most recently saved configuration settings. Note: Upon restart, if a configured dongle is connected, the switch will load the configured settings from it and save them into NVRAM.
The “Factory” button will reload
will also be saved to the dongle when connected.
Revision 071108 | Page 67 of 102 |