OSD (ON SCREEN DISPLAY)
GB
SYSTEM STATUS
When operating the system in DOLBY DIGITAL, DOLBY PRO LOGIC, OR 3 STEREO you can display the current status of your delay times and volume settings, press any buttons on the remote controller related to SURROUND, including SURROUND ON/OFF. This display will remain on screen for 12 seconds.
TEST TONE
In DOLBY DIGITAL, DOLBY PRO LOGIC, or 3 STEREO MODES, press TEST button. Test Tone scrolls automatically every 2 sec from left, center, right, rear right, rear left to subwoofer in continuous cycle.
Press the Surround button on the remote control, press the Test button, within five seconds select the channel you wish to adjust by pressing the volume up/down key. The volume level for the selected channel can be set by using the preset up/down keys.
If arrow up/down is pressed, test tone will stop moving to the next channel and will increase or decrease the level of the current channel, and the level in dB on the OSD will also change for that channel. When no button is pressed for 5 sec, test tone will continue to move to other channels. To exit and save the settings press test press test button to cancel test mode and memorize all change.
OSD “ON” POSITION
1When the SET UP button on the remote control is pressed, a display appears which shows the current status of the input being monitored. To change these settings, press the ENTER button to bring up the MAIN MENU. This is the only operation that can be performed on this menu, which will disappear after 12 seconds without input.
2When MAIN MENU appears, move the arrow cursor using the up/down buttons located above and below the ENTER button to select the function you wish to change, then press ENTER. This menu will remain on the screen for 20 seconds without input. If it disappears before you have made a selection, press the SETUP button then the ENTER button to bring it back.
3Entering INPUT SELECTOR from the MAIN MENU brings up a display that allows you to select the video input that you’d like to monitor. Move the arrow using the up/down buttons, then change the input source with the left/right buttons located on either side of the ENTER button. To get back to the MAIN MENU move the arrow to GO TO MAIN MENU and press ENTER.
20
