INTRODUCTION
PAGE 13
IdentificationofControls
Preparing the Remote Control | Operating with the Remote Control |
Insert the batteries into the remote control so you can use it to operate the DVD player.
1 Open the battery cover.
2 Insert batteries (AAA size).
Make sure to martch the + and - on the batteries to the marks inside the battery compartment.
3 Close the cover.
NotesImproper use of batteries may cause battery leakage and corrosion.
To operate the remote control correctly, follow the instructions below.
Do not insert the batteries into the remote control in the wrong direction.
Do not charge, heat, open, or
Do not leave dead or exhausted batteries in the remote control.
Do not use different types of batteries together, or mix old and new batteries.
If you do not use the remote control for a long period of time, remove the batteries to avoid possible damage from battery corrosion.
This section shows you how to use the remote control.
Point the remote control at the remote sensor and press the buttons
30 30
Within about 23 ft (about 7 m)
Distance : About 23 ft (7 m) from the front of the remote sensor.
Angle : About 30˚ in each direction of the front of the remote sensor.
Do not expose the remote sensor of the DVD player to a strong light source such as direct sunlight or illumination. If you do so, you may not be able to operate the DVD player with the remote control.
If the remote control does not function correctly or if the operating range becomes reduced, replace all batteries with new ones.
If battery leakage occurs, wipe the battery liquid from the battery compartment, then insert new batteries.
The batteries should last about one year with normal use.
Direct the remote control at the remote sensor of the DVD player.
Do not drop or give the remote control a shock. Do not leave the remote control near extremely hot or humid place.
Do not spill water or put anything wet on the remote control.
Do not open the remote control.