Napco Security Technologies GEM-K1CA Arming Aw Ay Setting The Alarm When Leaving, System Trouble

ARMING AW AY: SETTING THE ALARM WHEN LEAVING

SYSTEM TROUBLE

SYS/TRBL

L O W B AT TE R Y

E02-00 SERVICE

SYS/TRBL

C AN ’ T ARM S YS TE M P R E SS R E SE T K EY

SYS/TRBL

EXIT TIME 060 PLEASE LEAVE NOW

CAN’T ARM SYSTEM AREA X IN TROUBLE

System Trouble

If you attempt to arm with a “SYSTEM TROUBLE” display alternating with an indicated trouble code (e.g. “E02-00” (low battery); see SYSTEM TROUBLE ERROR CODES), a 3-second tone will sound at the keypad. The window will display “CAN'T ARM SYSTEM, PRESS RESET KEY”. If you cannot correct the problem immediately, pressing Cwill enable you to arm in this condition. Be sure to call for service as soon as possible.

Area Arming (Optional)

Some systems may be divided, or partitioned, into smaller independent subsystems, which are referred to as Areas. In a system that has been partitioned into multiple areas, one or more area may be armed while others remain disarmed.

Manager's Mode (Optional)

The Manager's Mode allows the user to arm / disarm other areas in a partitioned system. To arm/ disarm a different area:

1.Press the numerical key representing the other area number.

2.Press Gfollowed by U. The keypad will now provide status and control of that area.

3.Enter your User Code followed by Qto arm or disarm the area.

4.Press Gfollowed by Uto return to the home area.

Global Arming (Optional) (Available only with the GEM-P3200/9600 panels)

To arm all areas simultaneously, press 9, Gand enter your code followed by U. To disarm all areas simultaneously, press 0, Gand enter your code followed by U.

•The User Code must be valid in all area(s).

•If any zone is not secured, the keypad will display “CAN’T ARM SYSTEM, AREA X IN TROUBLE”, where X indicates the number of the Area in trouble. All faulted zones in the respective area(s) must be secured or bypassed. Note: If a system trouble is indicated, the system cannot be armed using this method.

7