Napco Security Technologies GEM-K1CA System Trouble Error Codes, Action, Indication, Condition

SYSTEM TROUBLE ERROR CODES

Trouble	System Trouble	Action
Indication	Condition
E04-NN	Wireless Transmitter	A problem has been detected with a wireless transmitter. Call installing company for service
	Supervisory Failure
E05-NN	Wireless Transmitter	The battery in a wireless transmitter is low and should be replaced. This transmitter is on the
	Low Battery	zone corresponding to the number NN. The replacement battery for the GEM-TRANS2 door/
		window transmitter, GEM-PIR motion detector and GEM-GB glass break detector is the Duracell
		DL123A 3 volt lithium. (2 required for the GEM-PIR and GEM-GB.) The replacement battery for
		the GEM-SMK is the Duracell MN1604 9 Volt Alkaline (2 required). The GEM-DT Dual
		Technology Sensor requires 4 C cell alkaline batteries.
		Warning: Replace batteries only with the same type as specified above. Use of another battery
		may present a risk of fire or explosion. Do not recharge or disassemble battery, or dispose of in
		fire.
E06-NN	Receiver Response	Call installing company for service.
	Failure
E07-00	Download Failure	Call installing company for service.
E08-00	Telephone Line Cut	The telephone line has failed. If telephone service has been temporarily interrupted, the trouble
		will clear automatically when it is restored. Otherwise, call installing company for service.
E09-00	System Cold Start

34