Napco Security Technologies GEM-K2AS manual Systbl, Exx-Xx, READY1, Cant/Arm, Area#

ARMING AW AY: SETTING THE ALARM WHEN LEAVING

T R O U B L E	SYSTBL/
A C O N	EXX-XX
T R O U B L E	CAN'T/
A C O N	ARM
	READY1
A C O N

	CAN'T/ARM/
A C O N	AREA#

If you attempt to arm with a “TROUBLE” display (alternating with a system trouble error code), a 3- second tone will sound at the keypad. (See SYSTEM TROUBLE ERROR CODES for descriptions of codes). The window will display “CAN'T ARM”. If you cannot correct the problem immediately, pressing Cwill enable you to arm in this condition. Be sure to call for service as soon as possible.

Area Arming (Optional)

Some systems may be divided, or partitioned, into smaller independent subsystems, which are referred to as Areas. In a system that has been partitioned into multiple areas, one or more area may be armed while others remain disarmed. In a multi-area system, the area number will be indicated by the right-most digit.

Manager's Mode The Manager's Mode, if enabled, provides quick access to other areas without the system status display. (This is NOT a high-security feature).

To arm any area:

1.Press the numerical key representing the area number.

2.Press Gfollowed by U. In effect, you will now "be" in that area.

3.Enter your User Code followed by Qto arm or disarm the area. Note: Your code must be valid in that area.

4.Press Gfollowed by Uto return to the home area.

Global Arming (For GEM-P9600/3200 panels only). To arm all areas simultaneously (including the area you are in), press 9, G, enter your code and press U.

If any zone is not secured, the keypad will alternately display "CAN'T ARM / AREA #", where "#" identifies the number of the area(s) in trouble. All problem zones in the respective area(s) must be secured or bypassed before the area can be armed. Note: If a system trouble is indicated, the system cannot be armed using this method.

To disarm all areas, press 0, G, enter your code and press U.

8