Napoleon Fireplaces EF30 Hardwire Installation, Electric Diagram, Remove 2 screws on cover plate

HARDWIRE INSTALLATION

ELECTRIC DIAGRAM

9

HARD WIRING CONNECTION

FIGURE 4

	10-10
		F
		L
		A
		M
M
		E
~		O
		M
		TOR
9-9

	1-1
H
EA	H
T	EA
ER	T
2	ER
	1
	2-2

	BLO
	W
	E
M
~	R
	M	2
	O
	TO	3
	R	5W
	3-3

P-L

2

3 5W

7-7 6-6

12-12

5-5 P-N0

PTC

8-8

t105!

POWER

If it is necessary to hard wire this

fireplace, a qualifi ed electrician may remove the cord connection, and wire the unit directly to the house hold wiring.

LThis fi replace must be electrically connected and grounded in ac-

cordance with local codes, if hard wired. In the absence of local codes, use the current CSA C22.1

		MOTOR H2		H1+
				FAN	LAMP FIRE
					10-10
IF YOU	PUT IN THE TEMPERATURE	RG		MAIN	CONTROL
SENSOR ON THE WALL.PLS CHOOSE 2			SIP2
		_
	2	[
t		k +	REMO.
TEMPERATURE
CONTROL SWITCH			TEM.
t
	1
TEMPERATURE	IF YOU USE THE
SENSOR	TEMPERATURE
	SENSOR.PLS CHOOSE 1				RECEIVER

4-4 P-NI

NCANADIAN ELECTRICAL CODE in Canada or the ANSI/NFPA 70-

1996 NATIONAL ELECTRICAL CODE in the United States.

CAUTION Ensure all power is turned off before hard wiring this fi replace.

1.Remove cover plate located beside the power cord to reveal the 7/8” wire hole. Discard cover plate, screws and insert a box connector into the hole.

2.Remove the lower back panel from the fi replace to expose wiring.

3.Remove the power cord strain-relief from the side of the fi replace and cut the cord where shown below. This will be the hardwire connection point.

4.Feed the supply wires through the box connector and the grommet.

5.Using wire connectors connect the common (white) wires together, then the hot (black) wires, and then the ground (green) wires.

6.Ensure the newly connected wires are kept away from the rotating parts and the circuit board, and re-install the back panel.

NOTE: This fi replace must be serviced from the back, leave enough wire so that the fi replace can be removed from the enclosure with- out disconnecting the power supply wires.

1

2

FIGURE 5

Remove 2 screws on cover plate.

FIGURE 6

Hot Wire

Common Wire

Ground Wire

FIGURE 7

Power Cord

Cut

3

FIGURE 8

Box

Connector

4Final Connection

W415-0675 / A / 03.28.08