16
FINISHING
DOOR INSTALLATION
GDLV LOUVRE INSTALLATION
Loosely thread a screw provided with the door kit into the top hole on the left side of the firebox. Hang the door by the hinge onto the screw. Insert the remaining 4 screws and tighten.
IMPORTANT: Ensure screws are driven in straight or the hole thread may be damaged.
FIGURE38
Remove the pro- tective plastic wrap from the louvres and install as illus- trated.
Clip each upper louvre into a slot on the louvre bracket. Ensure that the louvres are cen- tered within the opening.
LOUVRE
BRACKET
FIGURE40
UPPER LOUVRE INSTALLATION
DOOR CLOSING AND OPENING
Open the valve control door. | FIGURE39 |
Hook the top and bottom door |
|
| |
latches, located at the right |
|
side of the door into the corre- |
|
sponding slots in the door. |
|
The door latch holes are elongated for door levelling. To level the door, it may need to be lifted up at the right side before latching to ensure the door is level.
Prior to opening the door, lift up and remove the upper lou- vres or ornamental insets.
HINGE SCREEN
Remove the hinge screen, if factory installed.
FIGURE41
HINGE
SCREEN
FIGURE 42: LOWER LOUVREASSEMBLY
Screw the lower louvre assembly to the lip of the fireplace base as shown. Position the hinge screen into place and with the control door open, secure to the firebox using three screws.
