18
LOG PLACEMENT
PHAZERTM logs, exclusive to Napoleon Fireplaces, pro- vide a unique and realistic glowing effect that is different in
every installation. |
1
CHARCOAL STRIPS
1.Centre the two charcoal strips, as shown, along the inside front edge of the firebox.
Place the rear log #1 onto the locating studs along the back edge of the PHAZERAMIC™ burner.
2
2.Position log #2 onto the locators on the PHAZERAMIC™ burner.
3
3.Position log #3 onto the right most grate rail with the charred face to the front. Align the groove on the underside of the log, with the rail of the grate. Push the log back to the pilot housing. Log #3 should fit tight against log #2.
4
4.Place log #4, with the charred branch pointed inward. Locate the pins into the holes in log#1 and log#2, this will hold the rear log in position.
5
5.Place the end of log #5 on the right end of log #1. The fork in the log should straddle the knot on top of log #2.
GLOWING EMBERS
Glowing embers (not supplied) maybe used to enhance the flame's appearance.
BAFFLE INSTALLATION
Your fireplace has been supplied with the decorative brick panels installed. It will be necessary, however, to install the fibre baffle, on top of the side and rear panels.
CHARCOAL EMBERS
Charcoal provided should be randomly placed in the trian- gular trays on either side of the of the burner.
Log colours may vary. During the initial use of the fire- place, the colours will become more uniform as colour pigments burn in during the heat activated curing pro- cess.
Positioning the logs improperly will cause flame im- pingement and carboning.
Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. PHAZERTM logs glow when exposed to direct flame. Use only certified PHAZERTM logs available from your Napoleon dealer.