ACCENT LITE REPLACEMENT
Your Napoleon STARfire comes equipped with our “Accent Lite”. The light has been
It is recommended that the ACCENT LITE be in the off
position when the fireplace is on.
If in the event the lamp or lens needs to be replaced, follow the instructions below.
Unplug the light from inside the fireplace.
FIGURE47
LENSE
ASSEMBLY SCREWS FIGURE 48
FIREBOXI TOP
Remove the four screws that secure the lens frame.
This frame retains the glass lens. The lamp can
now be accessed.
FIGURE 49
Note: Do not handle the lamp (bulb) with bare fingers, protect with a clean dry cloth.
The lamp will pull straight out of the socket. Replace with Wolf Steel parts only, as lamp and lens are special “high temperature” products.
When
THE FIREBOX MUST BE SEALED.
Over tightening the screws could break the lens.
“Light Leakage” from the upper louvre area may be noticed. The holes in the lamp housing are necessary for ventilation and must not be covered.
19
IN LINE SWITCH
The FIRE LOG ACCENT LIGHT is provided with a manual "in- line" switch to turn the light on and off. There are alternate meth- ods of operating the light.
An example of one method would be to
This switch could be:
•Toggle
•Photo cell
•Remote
•Motion Sensor
All switches are available at your building store.
NOTE
ELECTRICAL INSTALLATION TO BE DONE BY A QUALIFIED INSTALLER and must be connected and grounded in accordance with local codes.
FIGURE 50a
FIGURE 50b