Napoleon Fireplaces GDI30 manual OUTSIDE Slip the one end of

9

While the liners must be continuous from the appliance to the chimney cap, to achieve the needed length, they may be coupled, using an approved coupler.

We recommend that exhaust vents that pass through unheated spaces, such as tall exterior chimneys, be wrapped in a protective sleeve to mini- mize condensation and reverse flow symptoms. See Trouble Shooting for details.

This appliance is approved for use with a 2" liner for air intake and a 3" liner for exhaust. For best performance, however, it is recommended to use two 3" liners.

If a 2" liner is used for the intake, it may be necessary to adjust the primary air shutter.

FLASHING

PLATE

2” OVERLAP INTAKE

SEALANT EXHAUST HI-TEMP

2.2.1 OUTSIDE: Slip the one end of	2"	3"
		LINER
a liner a minimum of 2" over	LINER
the sleeve of the air terminal.
Secure using 3 screws. Then	HI-TEMP	SLIDER
seal the joint and screw heads
with high temperature sealant.	SEALANT
		CONNECTION
Repeat with the other liner.	2"
		ILLUSTRATED WITH A 2"
NOTE: We recommend that	OVERLAP	INTAKE LINER.
the other end of the exhaust		MOUNTING
liner be marked to eliminate	REDUCER	PLATE
the exhaust liner being con-
nected to the intake collar at
the appliance.
2.2.2 Gently stretch the liners to the required		EXHAUST
lengths and insert into the chimney. Trim
and fit the flashing plate to suit the chimney		INTAKE
termination. Place the air terminal onto the
top of the chimney. Make weather tight by
sealing with caulking (not supplied). Fasten
to the chimney with screws and plugs (not
supplied).

2.2.3 INSIDE: Remove the securing screw from the front of the vent mounting plate. Pull the vent mounting plate only, back into the track,

to the front stop. Start the slider back into position. Re-secure the screw. The insert

may now be pushed into its final position inside the wood burning appliance, and the

screw tightened until the slider has been pulled tight to the front stop.

SECURING SCREW

2.2.4Route the flex liners through the slider. Attach and secure the liners to the vent mounting plate using the same procedure as before, ensuring that the marked exhaust liner is attached to the exhaust collar.

W415-0806 / 06.28.09